Block wall bathroom: framing, flashing and waterproof membrane before the new tile

This bathroom had block walls, an old tile floor and a tub wall that needed to be rebuilt. The photo above shows the main part of the work done: waterproof membrane laid across the base and up the walls, ready for tile. Getting there took several steps.
Framing around the drain
The drain and the area beside it were framed with new wood, and the existing flange was checked before anything else went down.

A curb and a flat floor
A wood curb at the edge of the wet area keeps the shower contained, and the board against the wall is fastened flat. The existing tile floor outside the area stays protected.

Stripped down to studs and block
On the tub wall, the old finish was removed to the block and new studs were fastened over it, with copper plumbing running through.

Looking at the base of the wall, the studs sit tight to the block and the pipe is fastened at the bottom.

Staging the wall like this makes it easy to check every connection and fasten everything where it needs to be.
Membrane on the floor and walls
Sheet membrane is laid across the floor and turned up the walls so there is no weak spot at the corner. The printed instructions on the sheet are the manufacturer's guide for overlap and sealing.

From here, tile can go down over a surface that is flat and water-tight.
Planning a bathroom rebuild with older walls? Request a free estimate and we will look at the job and quote it clearly before we start.
Need a hand with a project?
Book the VOL Handyman team for the work in this article, or anything else around your home or business.



